BERGEN Professional Trade Quality 17 Pce Compression Tester for Diesel Engines - NEW

Bergen Tools, need we say more.

BERGEN TOOLS, WPI Technic, need we say more.

This compression testing kit includes fittings suitable to replace injectors and glow plugs. Refer to the table for details of fittings and thread patterns.

This cylinder pressure tester gives you accurate readings for most models of cars, vans and trucks.

Suitable for diesel engines.

The quick release pull down coupler makes for a quick change between hoses and adapters.

Specifications

Gauge with PSI and BAR readings
0-1000PSI
Quick release push button valve
Flexible hose
14 x adapters
Box Dimensions: 37.5cm x 27cm x 7.5cm

Included

(Please refer to the numbered diagram for parts) 1. Glow plug adaptor: 91mm M10 x 1
2. Glow plug adaptor: 119mm M10 x 1
3. Glow plug adaptor: 135mm M10 x 1.25
4. Glow plug adaptor: 118mm M22 x 1.5
5. Dial gauge: 340mm
6. Glow plug adaptor: 113mm M10 x 1
7. Glow plug adaptor: 102mm M10 x 1
8. Glow plug adaptor: 83mm M10 x 1
9. Glow plug adaptor: 64mm M10 x 1.25
10. Glow plug adaptor: 47mm M12 x 1.25
11. Screw adaptor: 160mm
12.Injector adaptor: 88mm M24 x 1.5
13. Injector adaptor: 73mm M22 x 1.5
14. Injector adaptor: 63mm M24 x 2
15. Injector adaptor: 75mm M20 x 1.5
16. H fitting
17. Bleed valve

Notes

Before each use, check if any part of this product is damaged or missing, check carefully that it will operate properly and perform its intended function.

Do not use if defective.

Before use

Identify the size of fitting that is required for the engine to be tested.

This compression testing kit includes fittings suitable to replace injectors and glow plugs.

Refer to the table for details of fittings and thread patterns.

The battery and starting system must be in good condition to ensure an accurate test.

Operating instructions

WARNING: Always keep well away from any hot / moving engine parts. Take care to keep compression tester from becoming entangled in moving parts.

Attachment

Allow engine to reach normal operating temperature. Stop engine, remove all glow plugs or injectors (refer to vehicle manufacturers manual).

The compression tester (with correct fitting attached) can now be screwed into a glow plug or injector hole. Ensure that fitting is screwed in securely.

Disconnect the fuel shut off solenoid to disable the fuel injection pump.

With the throttle in the wide open position, turn the engine over 6-8 revolutions. The dial gauge (5) will automatically record the highest pressure reached. To release the pressure, and reset the gauge, depress the bleed valve button (17). The compression tester can now be unscrewed, and the next cylinder tested.

Maintenance

Keep your compression tester clean. Ensure that screw threads do not become dirty. If necessary clean with a wire brush.

Please note: The case Colour may change depending on batch Blue,Black,Red or Orange

Made by professionals for professionals.

RRP - £199.99