KIPOR Mains Transfer Switch 100amp Automatic Transfer Switch (ATS) - NEW
The KIPOR auto mains transfer switch system (ATS) monitors incoming voltage from the grid to other sources 24 hours a day, 7 days a week. The instillation of this switch does not affect your electrical system.
When power from the grid (or any other source such as a battery bank / wind turbine system) fails the transfer switch senses the voltage drop and signals the generator to start. The Kipor automatic transfer switch will then safely disconnect the usual supply line and open a new power line from the generator. Within seconds the generator will begin supplying electricity.
During a power outage, the Kipor mains transfer switch (ATS) will monitor the mains power for a period before it is satisfied that mains voltage has returned at a consistent and acceptable level. Only then will the Kipor mains transfer switch (ATS) transfer the electrical load back to the mains source and shut down the generator (standby).
During normal standby, the Kipor mains transfer switch (ATS) will trickle charge the 12V starter battery on the generator to ensure it is fully charged.
The Kipor mains transfer switch (ATS) is simple, cost effective and only takes a few hours to install.
Features
This ATS switch is suited for the kde6700ta and the kde12sta
This is an ATS switch for single phase generators
These units must be wired for the ats switch
This switch is compatible with: KDE6700TA, KDE12STA
Specifications
100 Amp
380 x 280 x 150mm (L x W x D)
Sturdy Steel Wall mountable Latched box
17pin (F-F) 5m cable
17pin Male Outlet
Wall mountings: 310 x 200mm (fittings included)
RRP - £599.99